It is a bear to get access to the back side to clean it. No burn marks, bubbles, etc By the way, can anybody tell what is the laser printer with cheapest toner cartridge? When the printer prints on paper from the manual feed the alignment is perfect. Align the paper with the guides and keep it straight so it feeds correctly. Jack, I assume you were using the parallel printing cable.
|Date Added:||5 January 2008|
|File Size:||30.95 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Open the manual feed tray.
If it did that engine test, the only thing you didn’t test was the formatter board. I will probably have more questions but that’s it for starters.
Always check the status lights first when laserwriterr printing problem occurs.
Printer: Apple LaserWriter Select | OpenPrinting – The Linux Foundation
It is just that with two flat bulky ends one. My is suddenly smearing black on one edge of the paper. Theoretically, the printer shouldn’t work if the heat lamp isn’t coming on. The troubleshooting guide I downloaded doesn’t even mention that part. Multipurpose tray, which automatically feeds up to 50 sheets of variable paper sizes. Snap each of the four plastic retainer clips into its slots to lock the upper and lower feeders together.
If you want to use paper that is different from the paper in the cassette, you can use the manual feed tray to insert sheets one at a time as the document is printed.
Apple LaserWriter Select 360 Printer
Did I forget to check something? Have not tapped the tray out yet.
Thank you – Tom. It describes your problem exactly. If the drum turns fairly easily, then you might just learn to live with the noise. LocalTalk option, EtherTalk option . I tested it and it works ok but i want to clean it inside could you help me with some service manual pdf or the Laserwrietr that I could look for?
Important Make sure the sliding backstop clicks into the appropriate notch. It should give you the same indication that you got when it burned out. As for the test page when I turn the printer on it was disabled, nor does it print out the test page once it is added as a printer in XP; it just gets an error. If so, then you’re pretty much on your own as there are way too many places you could have screwed up and we have no idea what you took apart that you weren’t supposed to.
File:Apple LaserWriter Select jpg – Wikimedia Commons
Have I done someting wrong in the Fuser Lamp Installation? This printer could print at forty characters per second.
This laserwritr a hand me down machine with no manuals. Uses a Panasonic UF Samsung and Brother are classified as “disposable” printers. The printer came without the jumper on jumper 1 installed so I selected 9 on the selector panel and when I powered the printer up I got the paper jammed light flashing after all three flash.
Many thanks for that Alan If Background Printing laserwrited turned off, there is 630 alert message on your screen. Replace the paper cassettes into the feeders, plug in the power cord, and turn on the printer. I found your site and purchased both your kits for this printer and followed instructions per the DVDs. They produced print quality that was better than the dot matrix ImageWritersand were cheaper than the LaserWriters. If the cartridge drum has significant resistance when you try to manually rotate it by turning the gear, then that could cause damage to the printer.
I have a laserwriter and pc with xp, connected via a parallel port.
First of all, it’s doubtful it’s the lamp.