LABVIEW STEPPER MOTOR DRIVER

Hi Steve, What motion controller are you using? Using the counters of a E- or M-Series board to control a stepper motor is not recommended, as this method doesn’t provide features that are typically required for a motion control application e. Please continue the discussion in your new thread here: Motion Control and Motor Drives: Message 1 of Message 9 of There are many different considerations when troubleshooting a motion system, so as much information as you can provide would be helpful for us to help you get started!

Uploader: Dale
Date Added: 8 April 2009
File Size: 17.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29628
Price: Free* [*Free Regsitration Required]

Motion Control and Motor Drives: Please continue the discussion in your new thread here: There are many different considerations when troubleshooting a motion system, so as much information as motog can provide would be helpful for us to help you get started! Do you have the NI-Motion drivers installed?

Thanks for your time and concern.

Controlling a Stepper Motor with LabVIEW – Discussion Forums – National Instruments

Steve J, Did you ever get a proper response from this posting? I need to sync the motion of the stepper motor with my data acquisition.

  KINGSTON DATATRAVELER100 DRIVER DOWNLOAD

Message 5 of I have a similar program to write in that it is also to use Peter’s board. Basically, I have to acquire the data in a way that in the start the motor will come back to home position wherever it was and then I want to move it to the specific position to do the measurements For Example, I want to measure the 40 GHz channel between 1m to 3m movement of a stepper motor labivew a linear positioning system ball-screw.

Most Active Hardware Boards: Message 6 of If I success in this project I will get my degree. I am new to labview It’s really urgent please and I’m labvlew this thing first time so please guide me in a proper way.

NI Stepper Motors – National Instruments

Message 7 of I would also specify what hardware you actually have controller, drive, etc. Is it an NI board? Best regards, Jochen Klier National Instruments. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches sfepper you type.

Did you ever get your LV program to work?

Message 1 of Message 10 of Message 4 of Please let me know what motion controller you have so that I may give you further assistance. Hi, I’m not sure whether this is the right place for asking this question or not and if not, then please guide me to the right place for asking such question.

  CANON I950 WINDOWS 7 X64 DRIVER DOWNLOAD

Using the counters of a E- or M-Series board to control a stepper motor is not recommended, as this stelper doesn’t provide features that are typically required for a motion control application e. Is there any one to help me please?

Message 2 of Please have a look at this thread.

NI Stepper Motors

Motion Control and Motor Drives. This thread is pretty old, so I would recommend making a new thread on our motion control forum labvieww that people in the community reply: I don’t really care what speed the motors run at or any of that, I just need a program that can run these stepper motors.

I shall really apprecaite that and will be highly obliged with you. Message 3 of