Dont try to over-run the capabilities of the device’s like gaming with a max integrated video memory of 32 meg’s and running a game that requires this just to operate. Remember to have a large work table so you can put the screws, etc. Sexually explicit or offensive language Spam: The cpu was getting too hot during cpu intensive tasks so it would lock up. This was helpful 0.
|Date Added:||27 April 2016|
|File Size:||67.63 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Noticed someone else trying to explain repair Glad to visit this place and see people getting results! I’ve noticed that the fan is kicking on alot more and staying on alot longer than it used too.
These controlled temperature and humidity ranges and added to the longevity mis-spelled?
Pay close attention to cable routing, etc. I have been an electronic technician for many years and I beleive that I can do as good or better of a job than they could.
Alot less laptops would have vdieo come our way. Laptops are subjected to some stresses that they don’t account for, but SOLDER is not a proper mechanical retension item.
Gateway YGR 15in. Notebook/Laptop – Customized | eBay
Sadly I see gatewag web pages explaining basic mechanics of how to tighten loose nuts. CNET’s Forum on laptops is the best source for finding help, troubleshooting, and getting buying advice from a community of experts.
Hi, Anybody can tell me how I can reach the motherboard of this laptop, in order to fix the CPU heat-sink problem as described, for example, by Mr. It worked for me, so Good luck, more questions? I really enjoy reading where people dive in and fix it!
Gateway ygr Problems – Forums – CNET
Basically it expands and contracts at a much lower temp causing the joints to crack and fail. I then used a Dremel tool to very slightly grind down the MB side of each pem nut so I could use screws to hold them down all four to the MB securely and also I resoldered all four of the pem nuts.
The cpu was getting too hot during cpu intensive tasks so it would lock up. There vieo a ton to list with this issue and M is absolutley correct in stating solder has no “holding” ability in this area. You are posting a reply to: Thanks for your assistance. Dont try to over-run the capabilities of the device’s like gaming with cideo max integrated video memory of 32 meg’s and running a game that requires this just to operate.
Cleaned the top of the cpu also denatured alcohol.
Reattached the heatsink and reinstalled gatewway Problem gradually became worse. Flaming or offending other users Illegal activities: Not too complex is it? The pem nuts protrude too far past the board so a screw won’t hold them securely, thus the slight grinding. That’s how I did it and you will see what I mean when you get inside.
Gateway 600ygr Problems
Cleaned the heat sink and applied silver heat sink grease. A good tech can clean this up in under an hour. My YGR was locking up alot and running hot and the fan ran pretty much all the time.
Is there any solution to this or am I dealing with a lost cause? It is now July Promote cracked software, or other illegal content Offensive: Sorry, there was a problem flagging this post. Yes bro, there is a solution.