BEIYANG BTP-2200E USB DRIVER

Select the print mode: Self-test page sees appendix 1 ; 2 3 The configuration describes the current settings of the printer. Then the print job stops, the host fails to communicate with the printer. B Auto Checkout functions Before starting the print job, the printer shall compare the parameter set by customers with current parameter of the printer to decide if it shall initiate the checkout with the process as below: When turning the knob in clockwise, the THP pressure increases along with level number.

Uploader: Tuk
Date Added: 13 September 2014
File Size: 41.47 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41988
Price: Free* [*Free Regsitration Required]

The print side should be upside.

The installation method of the driver: When data is transmitted, the host should not ignore Busy signal, otherwise it could cause the print data lost; Parallel interface signal uses TTL level.

In case of such condensation, do not turn on the power until it has completely gone away. When loading the paper, please put the label mount through the peel-off module according to the process as below: Operation method is as below See figure 2.

When using it, ensure that up and down time of host signal is less than 0. Trademark Our registered trademark Safety warning Caution: The configuration information and internal font presents the current settings of the printer.

BTPE E USER MANUAL V1 0_百度文库

Check the THP test page is Normal until its temperature is down. It shall enter pause status after success. Serial interface and Parallel interface are standard interfaces of printer, RS interface is standard Serial interface, Centronics parallel interface accords with IEEE If the printer cannot start or work normally, please contact with our distributors or beiiyang.

  LINKSYS EG1032 V2 DRIVER

REB user manual V If users need the further data about these products, please feel free to contact our market department or your local distributor.

If they are different, please correct and print it again. The printer shall restart Auto checkout. The steps for cleaning the THP are as below: Adjust the printout in horizontal direction with 8 dots as a motion unit. User can beiyanv choose USB interface to replace Parallel interface.

This will help to keep the THP durable. If the problem still cannot be removed, please contact with our distributor or manufacturer.

If the print finishes just now, please wait for the THP cool down completely; 3 4 Clean away dusts or dirt on the THP with alcohol tampon should twisted ; Wait for 5 to 10 minutes until alcohol volatilizes completely, then press down ribbon holder and close top cover. Only when the printer checkout is correct, it can work normally.

The figure above takes the marked paper as an example to show the print and paper out beiyng Non-continuous paper is positioned based on the front edge of marks; The position adjustment of the print and paper out refer to Figure 3.

  BROTHER HL 1440 1450 1470N 1.72 DRIVER

The printer finds out USB device drive path and installs this driver depending on this guide.

BTP-2200E Barcode printer,Direct thermal, 203dpi,Free shipping

User can execute the installation depending on the current port. In normal print, follow the pressure level of factory default settings, normally at level 2 or 3. Then the print job stops, the host fails to communicate with the printer. Please refer to 2.

No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose without the express written permission of SNBC. Self-test page sees appendix 1 ; 2 3 The configuration describes the current settings of the printer. When connecting USB interface printer to the host, the system identifies USB device automatically and pop up the driver installation guide.

After pressing pause key, the printer shall exit pause status and print; 3 If the checkout fails, the printer shall alarm: Power LED always light. Provides important information and prompts for printer operation. Select the print mode: